Installing Kitchen Sink Drain

Installing Kitchen Sink Drain -

Opting for this drain clog remover tool is a more economical choice compared to calling plumbers.Use a hacksaw or pipe cutter to trim the drain pipe to the appropriate length.

Grab that pencil and trace the outer edge, marking spots for the tap and waste pipe.See professionally prepared estimates for kitchen sink.Start with lining the rim of your basket strainer with plumber's putty.

You can find brass tailpieces at hardware stores and home improvement stores.Remember, the hole should be snug, about 10mm in from the edge.

Install the underside of the strainer.Clean off any excess plumber's putty using a wet cloth.Wrap the putty around the circumference of the sink basket.

Use our free homewyse calculator to estimate fair costs for your specific project.Once it's in place, screw it in until it's tight.

Cut the tailpiece and continuous waste pipe to the proper length using a pvc tubing cutter or a hacksaw.Set project zip code enter the zip code for the location where labor is hired and materials purchased.You want this to measure 16 inches or less.

A continuous feed disposal costs around $175 to $200 and a batch feed disposal is around $225 to $250.Next, take the locknut and thread it onto the sink strainer from underneath the sink.

Start by shutting off the water supply to the sink.Pipe wrench and/or strainer locknut wrench.Continuous feed and batch feed.

Measure and cut the drain pipe: